Figure 1 of 2 Wheel rim
Parts
All Geometry Sample Parts
All our parts have a story behind them. Explore sample parts below to uncover applications, materials, technology and geometrical fittings that might be right for your next project.
Figure 2 of 2 Passenger side airbag inflator and cross-section
Figure 1 of 2 Passenger side airbag inflator and cross-section
Side-impact airbag inflators
Driver and passenger side airbag inflators
Hybrid passenger side airbag inflator
Passenger side airbag
Driver side airbag inflator - cross-section
Figure 2 of 2 - Transition joint for cryogenic application
Figure 1 of 2 - Transition joint for cryogenic application
Solid aluminum bar to stainless steel tube
Pin heading done using interrupted weld cycle
Copier fuser roller
Electrical connector
Tensile specimen
Bi-metallic pump motor shaft. SS stub joined to CS shaft for corrosion resistance.
Marine outboard engine drive shaft
Bar stock welded to clevis forging for manufacture of large (5 inches (127 mm) diameter and larger) piston rods
Hydraulic piston rod
Track adjusting yoke for commercial tracked vehicles
Hydraulic piston rods. Rod eyes cut from heavy-wall tubing welded to pre-chromed bar stock.
Torque rod. Forged eye welded to various barstock lengths.
Truck rear suspension link welded on twin 150 Inertia Welder. Ends are oriented to within ±1° of each other.
- Go to page 1
- Go to page 2
- Go to page 3
- Go to page 4
- Go to page 5
- Go to page 6
- Interim pages omitted …
- Go to page 8
Clear All Refinements